The bolt from Wilkinson Tremolos, used to secure the whammy arm into the plastic bushing, by screwing into the block.

Fits both push on and screw on arms.

Simply a case of dropping the arm into the hole on the Trem, then tightening the hex bolt at the back to keep it in place. 5mm at the trem end.

Available in Gold w/Black Tip, Chrome w/White Tip or Black w/Black Tip.

5mm External thread. Should be a perfect replacement for most vintage USA trems, as well as many imports. Simply Screws into the threaded hole in the block. M5 thread
Available in Chrome

Usually for Thin Block Tremolo's

Available in Chrome, Gold and Black

5.7mm External thread. Should be a good replacement for any thin block trems, as well as many imports. Simply Screws into the threaded hole in the block.

(1)

Right Handed, Thick thread Whammy Arm - No Tip

Available in Chrome, Gold and Black M6 External thread. Should be a good replacement for any thin block trems, as well as many imports. Simply Screws into the theaded hole in the block.

About 5mm at the trem end, simply force the ball end into the cavity and through a washer where it will hold. No need for hex keys or threads.  Available in Chrome, Gold and Black Only in Right handed

Simple enough job. Just Push in the Arm and tighten the hex bolt to hold it in place.

Floyd Rose Push in Trem Arm 6mm diameter.

Available in Black or Chrome

Steel Tremolo Arm with a 5mm metric thread, used on the Axesrus 56.4mm Steel Block Trems, the 54 and 56.4mm Zinc and Steel block trems, and the Fender® Mexican zinc block tremolos, as well as many other tremolo systems produced outside of the USA.

Please note, these are not official Fender® parts.

Simply a case of dropping the arm into the hole and then screwing it onto the small protruding screw in the block. Nice and simple.

Available in Brushed Satin Chrome

M6 GLOSS CHROME TREMOLO ARM .
Check your Tremolo , these are M6 push in arms, No Tread or tip
Fits some of the old MK1 vs50 tremolos

About 5mm at the trem end, no need for hex keys or threads.  Available in Chrome.

A Gotoh F3 Tremolo Arm suitable for GE1996T Tremolo, available in a range of colours.

A Gotoh A7 Tremolo Arm suitable for Gotoh EV510T, NS510T, 510T, VS100N, VG300, VS401, VS401V Tremolos, available in a range of finishes.

Steel Tremolo Arm with a 10/32" Imperial thread, used on the Fender Vintage® Tremolo( 099-2049-000 ), the Gotoh GE101TS and many other trems either built in the USA, or to those all important "imperial" specifications.

Please note, these are not official Fender® parts.

Locking Trem Arm with Screw in Collar and bush - suitable for many different brands of Locking trem, as their a like for like replacement, or as a conversion to a push in arm.