This kit contains all the parts required to make a “stacked and shielded” noise cancelling single coil.

Nickel plated brass Eyelets, for fitting into pickup fiber board, giving you a point to thread the coil wire through, and to solder the hookup wires to.

Covers for DiMarzio HS, Virtual Vintage, Injector and Area Noiseless Single Coil pickups.

Covers for DiMarzio HS, Virtual Vintage, Injector and Area Noiseless Single Coil pickups.

Covers for DiMarzio HS, Virtual Vintage, Injector and Area Noiseless Single Coil pickups.

Covers for DiMarzio HS, Virtual Vintage, Injector and Area Noiseless Single Coil pickups.

Noiseless singles are absolutely jam packed with propriety parts frankly - but none of them are more important to the functionality then the "Gauss" plate.

Please note, these are not official Fender® parts.

A great alternative to a pickguard for mounting single  coil pickups in a guitar with that special finish

(2)

These covers are specifically for our Noiseless single coils and their relevant parts - taller then a normal cover to accommodate the stacked pair of coil, but, really, doing the same job as any single coil cover - just a plastic cover to protect the pickup itself.

This is a set of switch mounting and pickup height adjustment bolts for the Fender® Statocaster® and similar guitars.

Specifically, these are 6-32 UNC (imperial thread) bolts, with dome, phillips heads, with 6 "small" head screws for the pickups, and 2 larger headed versions for the switch, as well as 6 height adjustment springs.

(1)

This is a set of switch mounting and pickup height adjustment bolts for the Fender® Statocaster® and similar guitars.

Specifically, these are 6-32 UNC (imperial thread) bolts, with dome, phillips heads, with 6 "small" head screws for the pickups, and 2 larger headed versions for the switch, as well as 6 height adjustment springs.

Silicone tuning used on single coils, traditionally used in place of the springs (which have become much more common nowadays) - but the old silicone tubing has a bit of vintage charm about it.

Good quality Springs to hold Pickups against pick guards reliablly, with a little bit of play.

6-32 UNC bolts usually turn up on American/Mexican/UK made instruments and parts - primarily pickups and switches, but they are becoming more common on Eastern made things too nowadays - its a little bit confusing, because theres a few different "types" (and you do get guitars that have a mix of different heads/lengths) - so as a quick, rough and ready guide.

Steel pole pieces for the "Dummy" coil on our stacked, noise cancelling single coils bobbins.