These are the small brass screws traditionally used to mount a humbuckers bobbins to their base plates.

Go in eyes wide open here, these are BRASS screws - they're not as strong as a normal steel screw, and forcing them into a hole thats even marginally too small, or the material is too hard, will cause the heads to sheer off.

Our humbucker bobbins work perfectly with them (excluding the EZ bobbins (hole too large), Bobbins for Filtertrons, P90 sized humucker, and 8 string bobbins (hole too small - but obviously, would be re-drilled to accommodate) - anything with a 2mm hole, will work - any tighter, and they're in trouble. If in doubt, drill it out!

Quantity - 10
Material - Brass

Thread Dimensions
Width - 2.1mm
Length - 10mm or 12mm

Head dimensions
Width - 4mm
Depth - 2mm
Cross Head