Home > Machine Heads > Parts and Screws >

6 x Machine Head Bushes - Reducers
10.5mm Push In Machinehead Reducer Bushes


 
Alternative Views:


Prices From: £4.50 Inc VAT


Colour*:


Qty:  
Description Technical Specs
 
6.3mm shaft hole x10.5mm wide Splined Push in Reducer Bushes for 6mm Machine head posts. PER 6 Available in Chrome, Black, Nickel and Gold (Flat Top)

Average Rating: Average Rating: 4.5 of 5 4.5 of 5 Total Reviews: 2 Write a review »

  1 of 1 people found the following review helpful:
 
4 of 5 nearly perfect but be careful with the size January 1, 2014
Reviewer: Patrick Green from Colchester, Essex England  
I intended these bushes for 10 mm dia tuner holes and a 1/4 inch post tuners on some US tuners. (Waverley) The bushes are very good quality and robust but when the description says 6.3 mm it won't quite fit a 1/4 inch (6.4mm) post even though the waverley spec gave the post dia as 1/4 inch and 6.3 mm. I think there is some confusion over conversion here. Anyway this is not a problem as it took me less than 10 minutes to open them up with an old reamer I have. They are now installed and look and work fine.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 Compatibility December 22, 2012
Reviewer: Joe from Staffordshire  
I bought these specifically for my Gold Gotoh SD-91 Tuners (which are notoriously hard to find 10mm bushes for). As predicted, they did not fit over the machine head stem/shaft at first.  Luckily a quick email and the guys at Axesrus drilled another set of bushes to widen them slightly.  They dispatched them within the same hour and fit perfectly, saving me £10+ on actual Gotoh bushes. Absolutely superb service, I have never been let down by Axesrus.

Was this review helpful to you?