Wiring loom - For Stratocaster® - Solderless
OK - so wiring looms are a great way of upgrading and maintaining your guitar - most of the hard works already done for you to a high standard - and its just a case of soldering on the jack socket and pickups right?
Problem is - if you really dont like soldering, having the wiring done 90%, isn't really much use is it? So we've come up with this one! A completely solderless wiring loom for a Stratocaster®
Simply a case of pushing your wires into the screw terminals, tightening them up, and putting the thing in your guitar - couldn't be simpler.
As a nice little touch, we've put the mono socket wires and trem ground wire into the same setup too, so honestly, there isn't a single part that needs soldering now.
Beyond that, its all the same as the normal 5 way loom, just much simpler to install if you hate the idea of soldering!
Wired up, to order, here at Axes Towers in Hull, East Yorkshire, using CTS pots (250k, vintage audio taper) a Cornell Dubillier orange drop capacitor (0.022 @ 100v), an Oak Grigsby 5 way switch, all using 22 AWG vinitage cloth cover wired for the cleanest signal path possible.
And to top it off, its supplied with a top of the range Switchcraft Mono socket (short thread)
All in all, couldn't be easier to install - simply a case of connecting your pickups to the switch, connecting the jack socket, and connecting the spare ground wire to the trem claw to ground out the strings.
Please note, these are not official Fender® parts.
Fender®, Squier®, Stratocaster® and Strat® are registered trademarks of Fender Musical Instruments Corporation and Axesrus® has no affiliation with FMIC
Please note – these assemblies are made to order, and as such, come under the rules and regulations pertaining to custom work in regards of returns.
